COOPER FREESTANDING TUB FAUCET INSTALLATION

Transcription

1 SKU(s): COOPER FREESTANDING TUB FAUCET INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing fixtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, bathtub, floor, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Thread Sealant Adjustable Wrench Observe all local plumbing and building codes. Unpack and inspect the items for shipping damage. If any damage is found, contact our Customer Relations team at Level Hex Wrench Drill GETTING STARTED Ensure that you have gathered all the required materials that are needed for the installation. Pencil Safety Glasses For these instructions, it is assumed that the old faucet has been completely removed and any necessary repairs or modifications to the water supply have been completed. 1

2 INSTALLATION 1. Set the faucet base at its desired location, and mark the location of the mounting holes, as shown. Drill one ø12mm hole at each marked location. 3. Lower the faucet base into the drilled mounting holes, as shown. Remove the protective cover. Ensure that the base is level, and make adjustments as needed before moving on. protective cover cold water remove level faucet base this side facing bathtub longitudinal hot water 80mm 80mm horizontal ø12mm 2. Insert the provided expansion bolts through the bottom of the base, as shown. Slide the washer and locking washer onto the bolt, then slightly tighten the nut onto the bolt. Do not tighten fully. 4. Connect the hot and cold water lines to the inlets on either side of the faucet base, as shown. Ensure that the hot and cold lines are connected to the proper inlet. Apply plumber s tape or thread sealant to the threads before tightening. nut cold water line locking washer washer expansion bolt hot water line 2

3 5. Insert plugs into the s of the faucet base, as shown. Then, secure the flange to the base using the provided hex screws and hex wrench. hex wrench 7. Remove the hex screws, flange, and plugs that were installed in step 5. hex wrench M8x16 screw M8x16 screw flange flange plug plug 6. Perform a water pressure test before moving on. Ensure that there are no leaks in the connections. Note: If you are not familiar with performing this type of procedure, consult a licensed plumber. 8. Place the protective cover back onto the faucet base. Proceed to the installation of your finished floor before moving on with faucet installation. Important: The finished floor should sit flush, or a small bit higher, than the top of the protective cover. flow water floor flush with protective cover flow water 3

4 9. Remove the protective caps from the s on the facet body, to prepare for assembly. Assemble the faucet as shown below, to prepare for installation. hand shower cradle protective cap (remove) 10. Remove the protective cover from the faucet base. Lower the faucet onto the base, ensuring that the water lines are set into the water s. Fasten the faucet to the base using the provided hex screws and hex wrench. shower screw faucet body water lines protective caps (remove) escutcheon M8x12 screw 4

5 11. Use the provided flexible hose to attach the hand shower to the faucet body, as shown. 12. Once installation is complete, turn the faucet on. Allow the water to flow for approximately 60 seconds to check for any leaks. Ensure that hot and cold water are running appropriately. Divert water to the hand shower and run for another 60 seconds. hot cold open hand shower close diverter 5