THE INFORMATION PROVIDED IN THIS BOOKLET ONLY CONTAINS GENERALISED HINTS AND SHORTCUTS PROVIDED TO ASSIST OUR CLIENTS.

Transcription

1

2 THE INFORMATION PROVIDED IN THIS BOOKLET ONLY CONTAINS GENERALISED HINTS AND SHORTCUTS PROVIDED TO ASSIST OUR CLIENTS. IT IS TO BE USED AS A GUIDE ONLY AND MAY NOT BE RELEVANT TO YOUR PURCHASED PRODUCT. WE RECOMMEND YOU READ ALL OF THE OWNERS MANUALS PROVIDED. 1

3 INDEX 1. CARAVAN HINTS & FREQUENTLY ASKED QUESTIONS 1.1 Air conditioner Brakes Brake safe (break away) Cleaning Corner steadies Dust entry Fridge Gas Gas appliance operation Hot water system Microwave Raising and lowering of pop tops Roll out awning Service intervals Storage Stove Water pump Water tanks Window, door &lock information volt appliances Warranty procedures and repairers in W.A Service costs and intervals Service and maintenance Hook up and before travel Arrival and set up at a caravan park Arrival and set up for free camping pin plug wiring..11 2

4 CARAVAN HINTS & FAQs 1.1 Air conditioning Rooftop air conditioners installed into full height caravan s work extremely well due to the construction of the vans. Opening the door during hot weather will allow hot air to enter the small space of the caravan, forcing the air conditioner to work harder than normal. To avoid putting strain on the air conditioner, it is recommended that you keep doors and windows closed. Air conditioners for pop tops and camper vans will be less effective as the vinyl top skirt fitting does not have insulation. The gas vents which allow for the flow of air impact the effectiveness of the air conditioning. Please refer to your owner s manual for information on operating temperatures, as they have a cut out for both cooling and heating which may require the installation of other products to help. 1.2 Brakes If you run the brake controller fitted to your vehicle to high the breaks may overheat. If this occurs, stop to allow the unit cool down. Brakes should run cool to touch however, if vehicle is under heavy use of being towed through the city, the brakes will run hotter. Because the magnet makes contact with the brake drum, the door side will run warmer. This is normal because of the camber on WA roads but ensure the handbrake is off (all the way) and cables are loose. 1.3 Brake safe (Brake Away) Caravans with a GTM over 2 tonne require a break away unit fitted. There is a switch which has a pin and cord on the a-frame. In the event of a disconnection, it automatically applies the brakes and illuminates the stop lights. Some units have test buttons and 240v chargers, it is important to check the battery and charge when required. Leave battery plugged into 240v case supplied with charge cable. 1.4 Cleaning the RV Washing and cleaning the RV should be done with a clean sponge to avoid scratches on windows. Use car wash products for best results and after washing wax to maintain shine. 1.5 Corner Steadies Ensure that corner steadies are not used to carry the weight of the RV (only to provide a firm feel while camping). 3

5 1.6 Dust and the RV Why is there dust inside my RV? A pressure difference occurs inside and outside the van while it is being towed. This causes dust to enter from outside the van any way it can. To minimise this, a pressure hatch can be fitted to prevent as much dust getting inside the van. NOTE: Due to venting on caravans, some dust will still enter. 1.7 Fridge Lighting fridge: When lighting the fridge, follow the operation manual (some models are fitted with an ASES fridge which is automatic). If the fridge is manual; press and hold the gas button, then press the ignitor repeatedly until the dial indicator moves over to the green side, you can then release the gas button. Absorption fridges generally take up to 8 hours to cool, however some cooling may be felt after 2 hours. It is best to check that the vent is discharging heat. HINT: As absorption fridges are slow to cool, it is suggested that they are turned on at least 24 hours prior to use. Put items into the pre-chilled area to help with cooling. Keep the door closed for as long as possible to increase performance and stop cool air escaping. 1.8 Gas If you smell gas inside your RV, turn off the gas bottles immediately, open all available windows/doors to let the gas escape for at least 1 hour. Gas detectors are available for purchase. 1.9 Gas appliance operation When lighting gas appliances after filling gas bottles, ensure the gas line is connected correctly, be sure to turn the gas cock on the bottle on, then depress the gas fuse if fitted Hot water system Lighting gas: Ensure the HWS has a supply of water. Open the gas bottle and turn on at the face plate. Inside you will see the red light come on (this light will go out once ignited). You may hear a ticking noise after ignition, this is just a safety feature to ensure the unit stays lit Microwave The power lead is plugged into a power point in the cupboard adjacent to the microwave. NOTE: While travelling it is recommended that you wrap the glass tray in a tea towel or the original packaging to avoid breakage. 4

6 1.12 Raising/lowering Pop tops Ensure while lowering/raising the roof, the main door is open and latched back to allow air caught inside to escape/enter easily. Opening: The awning must be rolled out approximately 1m to raise the roof without putting tension on it. Closing: Do the same in reverse, ensure the doors are open and zippers are up, otherwise damage may occur. Note: Awning must be on close so that it rolls up on the barrel Roll out awning Ensure that both arms are locked and the catch is in the close position before proceeding to travel. If there is wind or rain, it is recommended that you keep the awning in the closed position. If you choose to leave the awning out during rain, ensure the arms are at different heights to allow the water to drain off the awning skin to avoid damage. It is recommended that you pack the awning away when storms or strong winds are forecasted Service intervals We recommend that your RV be serviced every km, or annually whichever occurs first. NOTE: New vans also require a 1000km / 3 month service 1.15 Storage It is recommended to wind the jockey wheel up/down while not in use. This allows water to run off RV during wet weather as caravan roofs are not level. Storing them front up/down stops water from pooling on the van. Pop tops can be stored up or down depending on storage location, but require airing out on hot days. Batteries should be on a charger from 240v timer or solar and the breakaway changed. Water tanks should be drained. Gas should be turned off Stove Lighting stove: Lift the lid and ensure it is back as far as it can go. Turn the knob to the highest setting and hold the piezo lighter don until lit (keep hold of lighter after releasing the knob to ensure it stays lit), then release the knob. WARNING: Do not use without ventilation in place. 5

7 1.17 Water pump Check that the pump is switched on (you should be able to hear it running). If you cannot hear it running, check the fuse and replace it if needed. If the unit is not bleeding air, check that one tank is selected and not turned off sometimes the main water pressure will come back through. If any debris are lodged in the pump, the tanks will fill slowly. Ensure the pump is turned off when not in use to reduce system noise and pressure Water tanks Water tanks must be filled gently with average tap pressure to avoid causing damage to the tank. If it is difficult to fill, the breather may have water stuck in it. Blow down to clear, then proceed to fill tanks. If the RV is fitted with more than one tank, there will be a changeover valve fitted. You can select one tank at a time or both Windows/doors Main door: It is important that doors are key locked before travelling to prevent them from opening during transit. Some pressure may be needed on the top and bottom so that they are in the correct position. Windows: Secure and lock before transit. Ensure blinds/screens are in the closed position. The windows occasionally stick to the rubber seal, this can be avoided by smearing a small amount of Vaseline to lubricate. The struts fitted require no maintenance however, if you have been in a dusty area, a spray of CRC is beneficial for smooth operation v appliances Please refer to owner s manual for detailed instructions on appliance use. Power points: All 240v appliances are plugged into a power point with a switch that turns them on/off. NOTE: Air conditioning is hard wired and cannot be unplugged. If you are unable to turn any appliances on, check that the RCD is in the on position and not tripped where plugged in Please note Never try to light any gas appliances if you can smell gas. The simple way to bleed to the gas system after bottle change/long storage time is to light the largest burner on the stove until the flame burns evenly. After this the other appliances should easily light. 6

8 Warranty procedures and repairers in W.A In order for you to have the best experience possible in your new RV you should be aware of the warranty information detailed below. As your RV is a mobile product and you are likely to be travelling all over Australia, below is a list of maintenance and repairers who work on Jayco caravans in WA. This list has been provided to minimize inconvenience to you if you are to have any concerns regarding your RV. Please note: While every effort is made to accommodate repairs to your RV, there may be delays on getting products in to carry out repairs. We will advise who is best to contact if this does occur. If you are unable to return the RV to us here at Caravanland for inspection/repairs, please contact one of the following repairers within WA. Overall Caravan 5 Glenister Loop Broome WA or Maintenance Ken Peachey Caravan 194 Campbell Street Belmont WA Repairs PDA Caravan Repairs 37 Eva Street Maddington Northside Caravan Repairs 22 Dellamarta Road Wangara WA Caravan Doctor 94 Strelley St Busselton WA Craigs Mobile Caravan 26 Tweak Way Maddington WA Service & Repairs The Caravan Shed 1/28 Hammond Rd Cockburn Central WA 6164 Care-A-Van 52 Mordaunt Circuit Canning Vale WA Absolute Caravan Care & Unit 1/16 Abrams St Balcatta WA Accessories Rockingham RV centre 87 Dixon Rd Rockingham WA Esperance Caravan & 55 Noresman Rd Esperance WA Camping Centre Wheatbelt Caravans 55 Old York Rd Northam WA Albany Caravan Repair 35 Regent St Gledhow Albany WA Centre Quality Mobile Caravan Mandurah Area / Repairs Mandurah Caravan Repair 38 Panton Rd Mandurah WA Centre South West RV Centre 55 Albert Rd Bunbury WA Caravan Workshop ( Unit 2 35 Halifax Drive Bunbury WA Emergencies Only) 6230 Metaland Kununurra 10 Ivanhoe Rd Kununurra WA (Running Gear Only) Country Time Caravans Flores Rd Geraldton Exmouth Caravan Servicing & Repairs Mobile Repairer

9 Carnarvon Tackle & Marine Lot A1 Harbour Rd Small Boat Harbour South Carnarvon WA Service cost and intervals Congratulations on the purchase of your RV, please find your recommended service times below First service 3 months / 10,00km (new RV s only) Second service 12months / 10,000km Then annually every year from date of last service There are several options available for your RV service. If you require any more information please contact the service team on: p: (08) e: service@caravanland.com.au The service centre is open Monday to Friday 7:30am 4:00 pm (excluding public holidays) 1ST SERVICE SINGLE $150 between 3-6 months WITH JTECH $250 1ST SERVICE TANDEM $250 between 3-6 months WITH JTECH $350 END OF WARRANTY $150 at 10 months CHECK 2ND SERVICE SINGLE $340 between months WITH JTECH $440 2ND SERVICE TANDEM $390 between months WITH JTECH $490 SERVICE SINGLE $350 yearly service SERVICE TANDEM $390 yearly service MAJOR SERVICE SINGLE $500 bi yearly service MAJOR SERVICE TANDEM $650 bi yearly service MOTORHOMES $150 yearly The servicing centre can also fit a range of accessories to your RV, please call to check availability and pricing of these items. *Prices correct as of 1 March

10 Hook up / before travel Always check the trailer plug on both the RV and vehicle to make sure they are working (keep clean and dry) Check wheel nuts and tyre pressure (150nm tyre pressure on vin plate) Handbrake is off/check cables are loose Front window shade is down and locked into place All towing aids are fitted correctly All external boot access points are closed and locked Corner steadies are wound up and stowed correctly Roll out awning travel locks are down/straps fitted Gas bottles turned off Check that lights are operational Check brake controller operation and adjustment Inside RV All 12v lights are off and plugs removed All windows are closed and blinds are open Roof hatches are down and locked All cupboards are closed and locked Set fridge to DC Remove TV/store in secure spot 9

11 Arrival and set up at a caravan park When you arrive at the parking spot at the caravan park, first check to see where best to park your van to suit your RV Park your RV on level ground as this will affect fridge performance Apply handbrake and chocks wheels if necessary Secure RV with corner stays (to reduce wobbling) Plug in water and 240v (power) Connect waste hoses Turn hot water on from under the cover outside RV (small switch on lower left hand side of HWS) Roll out awning (if using them) Lift awning up to desired height and pull down and lock awning knobs Pop tops and Campers: undo roof clips then wind up or lift roof Check 240v on Setec Turn the fridge onto 240v power Turn gas on if required for cooking Arrival and setup free camping When you arrive at your free camp area, select a camp spot that is level and is clear to avoid danger from falling branches et cetera. Park the RV on level ground as this will affect fridge performance Apply handbrake and chocks Connect waste hoses Turn water pump on Turn gas bottles on/depress the gas fuse if fitted Roll out awning Pop tops and Campers: undo roof clips then wind up/lift roof Check 12v on Setec Turn the fridge onto gas and light leave depressed until into the green section Wind down corner steadies to firm up the van (these are not jacks) Lift awning up to desired height and pull down and lock awning knobs Light hot water system by turning on at switch plate inside van 10

12 12 Pin plug wiring Fitting electric brakes and/or wiring the vehicle for a 12pin plug. The hot wire for number 2 must remain in place at all times, this is for the ESC (electronic stability control) system and auxiliary power. Operation for 12 pin plug follow table 1 below, and for a 7 pin and Anderson arrangement follow table 2 below (this is a must). Table1) 12pin plug pin function colour min. Wire special connection instructions Size (t) mm2 1 left indicator yellow v pos supply black 3 connect directly to vehicle battery from battery with a 20 amp fuse or auto breaker 3 ground white 3 connect to chassis of vehicle 4 right indicator green electric brakes blue 2 connect to brake controller 6 stop lamps red tail lamps brown n/c 9 fridge 12v pos pink 10 connect directly to vehicle battery direct from battery positive terminal 30amp fuse 10 fridge 12v neg white 10 connect directly to vehicle battery direct from battery negative terminal 11 n/c 12 n/c This is the factory supplied plug, wiring arrangement for ESC is run through pin, it doesn t require a separate feed. This is approved for use by Alko in this arrangement, and is safe to use in any condition that both the ESC and RV have been designed for. Please make sure when connecting the van up, the ESC lights up green or red. This will indicate that power is at number 2. 11

13 Notes 12

14 Notes 13

15 14

16 15