Addendum to the AE-Ti Heat Pump Installation/Operation Manual

Transcription

1 H C Addendum to Doc. H D Addendum to the AE-Ti Heat Pump Installation/peration Manual Please refer to the following pages for corrections to document H D. Please note and apply the following changes to the Installation and peration Manual included with this document. Page 6, Table 1, AE-Ti Heat Pump Technical Specification. eplace the table as follows: MDEL AE1500T AE2000T AE2000T--263 AE2500T AE2500T--263 AE3000T AE3000T--263 VLTAGE /60/ /60/ /60/ /60/ /60/ /60/ /60/3 UTPUT* 73,000 BTUs 103,000 BTUs 118,000 BTUs 135,000 BTUs CP* UTPUT, STANDAD ATING CNDITINS** 60,000 BTUs 87,000 BTUs 105,000 BTUs 121,000 BTUs CP, STANDAD ATING CNDITINS** MINIMUM CICUIT AMPACIT 28A 39A 23A 40A 28A 47A 31A MAX VE CUENT PTECTIN*** 50A 70A 40A 70A 50A 80A 50A HEAT EXCHANGE Titanium CMPESS 40K Scroll 60K Scroll 68K Scroll 81K Scroll CABINET EFIGEANT 56 z, z, z, z, -22 EFIGEANT HIGH PESSUE ALAM EFIGEANT L PESSUE ALAM L ATE FL ALAM MAXIMUM HEIGHT BEL ATE LEVEL MINIMUM HEIGHT ABVE ATE LEVEL PTIMAL ATE FL MINIMUM ATE FL MAXIMUM ATE FL Page 8, Add Section as follows: In order to meet Florida Building Code Effi ciency performance requirements and to deliver the rated performance at the AI 1160 Low Ambient Standard rating conditions, it will be necessary to install the heat pump in accordance with the following table: ABS 450 PSI (reset to 285 PSI) 30 PSI (reset to 74 PSI) 30 GPM 5 feet below pool level 11 feet above pool level 55 GPM 30 GPM 125 GPM AI FL 2060 CFM 4120 CFM ATE TEMPEATUE DIFFEENTIAL (DELTA T) Adjustable between 1 F to 5 F UNIN SIZE 2 EIGHT 225 LBS 325 LBS SUND PESSUE PE IS dba * Test Conditions: 80 F Air, 80% H, 80 F ater, utside the scope of AI Standard 1160 ** ated in accordance with AI Standard 1160 *** Max ver Current Protection refers to the maximum breaker size allowed. If this value is not a standard breaker size, use the next smallest standard size breaker. The breaker size must not be smaller than the Minimum Circuit Ampacity value. Model AE1500T AE2000T AE2500T AE3000T TXV Setting (Number of Turns pen)* 5.25** 5.25** ** efrigerant Charge (-22, z) 56** 72** ** * All models have adjustable TXVs ** Factory Set Pages 14 and 15, eplace Electrical iring Diagrams (Figures 8 and 9) with updated diagrams provided on pages 3 and 4 of this addendum.

2 Page 2 Page 17, Section 4.3, Bonding, eplace the last sentence of the CAUTIN Boxes with the following: For English: diameter than 8 ga (In Canada, it shall be not smaller than 6 ga.) For French: d un diamètre de calibe minimal 8 ga (Au Canada, cela ne devrait pas être inférieur à 6 ga.) For Spanish: de un diámetro no inferior a 8 ga (En Canadá, no será más pequeño de 6 ga.) Page 18, Section , Configure the AquaLink S Control System emove the last sentence in parenthesis at the end of step 1 that reads: (esistor is included with the Heat Pump.) Please note that the resistor is no longer included with the Heat Pump but can be ordered separately from your local Jandy service center. Pages 20 and 21, Sections 5.2.3, 5.2.5, 5.3.2, and Add the following sentence after the fi rst paragraph in the above sections. A Maintain Temp elay is required (provided) and feature must be enabled. Page 23, Table 3, ptimal ater Chemistry anges eplace Table 3 with the following table: Test ecommended Level Free Chlorine 1.0 to 3.0 ppm Bromine 2.0 to 4.0 ppm ph 7.2 to 7.8 Total Alkalinity (TA) 80 to 120 ppm Calcium Hardness (CH) 175 to 400 ppm Cyanuric Acid 50 to 75 ppm Total Dissolved Solids (TDS) 1000 to 2000 ppm (Excluding dissolved NaCl from Salt Chlorine Generator) Copper 0 ppm * Concentration levels taken from Basic Pool and Spa Technology published by APSP (Association of Pool and Spa Professionals). Table 3. ptimal ater Chemistry anges Page 29, Section 9.2, Jandy AE-Ti Heat Pump Parts List eplace existing item 17, Part No with item 17, Part No Delete existing item 22, Part No and add a new item 22, Part No , as shown on page 5 of this addendum and as follows: 17 Universal Union and Buttress Set All Thermal Expansion Valve, 5 Ton, Adjustable (Not Shown) 2,000, 2500, Page 30, Figure 18, Jandy AE-Ti Heat Pumps Exploded View eplace Figure 18 with revised artwork provided on page 6 of this addendum.

3 Page 3 24 VAC TANSFME PUMP TIME CLCK B MAINTAIN TEMP ELA CMPESS HEATE MDEL 3000 NL ELA L 1 MAIN CNTACT L 2 GUND ATE TEMP AI TEMP CAPACIT CMPESS CAPACIT B B/ CM G PE INTEFACE JVA INTAKE JVA ETUN AE SEIES VAC SINGLE PHASE 60 Hz IING DIAGAM B FACT INSTALLED 208/230 VAC ATE PESSUE SITCH B/ B FIELD INSTALLED 208/230 VAC FACT 24 VAC HANESS G HIGH EFIGEANT PESS SITCH L EFIGEANT PESS SITCH FACT 24 VAC FACT PTINAL 24 VAC FACT PTINAL 208/230 VAC CMPESS USE INTEFACE EVESING VALVE (PTINAL) HEAT EXCHANGE ANDE - ACK/NI/NEG - UE/EU/AZUL B - BN/MAN/MAN B/ - BN ITH HITE TACE/MAN AVEC UNE TACE DE ANC/MAN ANC G - GEEN/VET/VEDE - ANGE/ANGE/ANAANJAD - ED/UGE//J - HITE/ANC/ANC - ELL/JAUNE/AMAILL H B Figure 8. AE-Ti Single-Phase Electrical Supply iring Diagram

4 Page 4 24 VAC TANSFME PUMP TIME CLCK MAINTAIN TEMP ELA B CMPESS HEATE MDEL 3000 NL ELA L 1 L 2 MAIN CNTACT L 3 GUND -UT C THEE PHASE LINE VLTAGE MNIT ATE TEMP AI TEMP L1 L2 L3 CAPACIT B B/ CM G PE INTEFACE JVA INTAKE JVA ETUN AE SEIES VAC THEE PHASE 60 Hz IING DIAGAM B FACT INSTALLED 208/230 VAC ATE PESSUE SITCH B/ G B HIGH EFIGEANT PESS SITCH L EFIGEANT PESS SITCH FIELD INSTALLED 208/230 VAC FACT 24 VAC HANESS FACT 24 VAC FACT PTINAL 24 VAC FACT PTINAL 208/230 VAC CMPESS USE INTEFACE EVESING VALVE (PTINAL) HEAT EXCHANGE ANDE - ACK/NI/NEG - UE/EU/AZUL B - BN/MAN/MAN B/ - BN ITH HITE TACE/MAN AVEC UNE TACE DE ANC/MAN ANC G - GEEN/VET/VEDE - ANGE/ANGE/ANAANJAD - ED/UGE//J - HITE/ANC/ANC - ELL/JAUNE/AMAILL H B Figure 9. AE-Ti 3-Phase Electrical Supply iring Diagram

5 Page 5 Section 9. eplacement Parts 9.1 rdering Information To order or purchase parts for the AE-Ti model heat pumps, contact your nearest Jandy dealer or distributor. See the Jandy web site at for the nearest service center. If you still need help, contact Jandy Customer Service, P.. Box 6000, Petaluma, California, 94954, Telephone (707) extension Jandy AE-Ti Heat Pumps Parts List Key No. Description Model No. rder Part No. 1 Top Enclosure, Jacket Top Enclosure, Jacket 2000, 2500, Service Access Panel All Control Cover - Smoked All Fan Motor, 1/6 HP, VAC Fan Motor, 1/2 HP, VAC 2000, 2500, Contactor, 1-Phase All Contactor, 3-Phase 2000, 2500, Transformer, 240V 24VA All ater Pressure Switch All Capacitor, Fan Motor, 3/370 MFD Capacitor, Fan Motor, 7.5/370 MFD 2000, 2500, Capacitor, Compressor, 60/ Capacitor, Compressor, 80/ , 2500, Controller Assembly, Universal All efrigerant HP Switch All efrigerant LP Switch All efrigerant LP Switch (Heat/Cool) 2500, ire Harness Kit (Not Shown) All Fan Blade Set Fan Blade Set 2000, 2500, Fan Guard Fan Guard 2000, 2500, Plumbing Bypass Assembly All Universal Union and Buttress Set All Evaporator Coil/Guard Evaporator Coil/Guard Evaporator Coil/Guard Evaporator Coil/Guard Heat Exchanger Drain Kit (Not Shown) All Heat Exchanger eplacement Kit Heat Exchanger eplacement Kit 2000, 2500, Compressor (40K), 1-Phase Compressor (60K), 1-Phase Compressor (68K), 1-Phase Compressor (81K), 1-Phase Compressor (60K), 3-Phase Compressor (68K), 3-Phase Compressor (81K), 3-Phase Thermal Expansion Valve, 2 1/2 Ton (Not Shown) Thermal Expansion Valve, 5 Ton, Adjustable (Not Shown) 2,000, 2500, ater Temperature Sensor All Phase Monitor (3-Phase Models nly) (Not Shown) 2000, 2500, Air Temperature Sensor All eversing Valve (ptional, Not Shown) 2500, Achor Bracket Set (Not Shown) All Heat Pump Drain Kit (Not Shown) All Junction Box Cover All Power Interface PCB All Fan elay All

6 Page UE IE ED IE ELL IE ANGE IE These pressure switches are installed in the refrigerant line near the compressor 20 A B DETAIL A 8 DETAIL B Figure 18. Jandy AE-Ti Heat Pumps Exploded View

7 Notes Page 7

8 H C Page 8 Jandy Pool Products, Inc Condor Drive, Moorpark, CA, USA FAX Litho in USA 2008 Jandy Pool Products, Inc. 0802