PARTY TENT SEMI PRO, CombiTent 8m Series - Side height 2,6m SH

Transcription

1 PARTY TENT SEMI PRO, CombiTent 8m Series - Side height 2,6m SH

2 Safety Advice Attention In some countries approval is needed to set up a marquee/tent larger than 75 m2. It is your responsibility to comply with local rules and regulations and to ensure that the marquee/tent is assembled correctly. In case of bad weather conditions, it is your responsibility to ensure the marquee/tent is safely secured and that the marquee/tent does not cause damage to others. close to the tent. The marquee/tent must be safely secured. We recommend you secure your marquee/tent with straps and pegs as soon as it is assembled. Make sure to check if the marquee/tent is covered by your home contents insurance. Marquees/tents must be evacuated under extreme weather conditions. In the event of snow always remove snow from the roof of the marquee/tent regularly to prevent snow from building on the roof as heavy snow can cause the marquee/tent to collapse. In the event of rain there is a risk of rain puddles building up on top of the roof of the marquee/tent. Heavy rain puddles can cause the roof to collapse. It is your responsibility to ensure rain puddles do not build up. As a precaution, make sure the roof of the marquee/tent is stretched out properly and adequately over the side frames of the marquee/tent and remove rain water regularly. Do not unpack or repack your marquee/tent in freezing temperatures. In case of temperatures below zero always unpack and repack your marquee/tent indoors to avoid the risk of cracking parts. The marquee/tent must be totally dry before you repack and store it to avoid mildew. Note: Marquees are intended for events and other arrangements and are as such only meant for short term temporary assembly and the following disassembly. Dancover warranty applies only to the normal use of the Product, normal wear and tear excepted, in accordance with written use instructions or manual. The warranty does not apply to Warranty Information Please visit dancovershop.com for information on warranty.

3 8m Series -2,6 PARTY TENT SEMI PRO, CombiTent Dimention No. 8x12m Q uantity 8x16m Quantity 50X1.5MM 2188MM 37x1.1mm 1880mm 50X1.5MM 1950MM 25x0.8mm 750mm 25x0.8mm 1987mm X1.5MM 00MM Three-way Three-way Four-way Four-way no rings 6 8 no rings SH

4 8m Series -2,6 PARTY TENT SEMI PRO, CombiTent Flat Threeway 11 Flat fourway Foot base for corner on right Foot base for corner on left Foot base for 15-1 sidewall Foot base for endwall Turnbuckle set for side SH

5 8m Series -2,6 PARTY TENT SEMI PRO, CombiTent Turnbuckle set for roof surperpeg x300mm spiral 20 6x180mm x180mm Long bungeeball Short bungeeball rope 25 M6X30mm +nut screw SH

6 8m Series -2,6 PARTY TENT SEMI PRO, CombiTent M8x50mm screw M8x60mm screw locknut spancer roof 33 1 ( sections) 1 sidewall endwall with large door endwall with small door SH

7 CombiTent roof explanied 8x6 8m -2.3 PARTY TENT SEMI PRO, COMBITENT m section with 8x8 m section with out 8x10 m section with m section without 8x12 m section with m section without out 8x1 m section with m section without m section without 8x16 When you are making your CombiTent shorter. Use 1st. Velcro the velcro overlay to detach roof sections. Roofcover m section with 2nd. Velcro m section without Roofcover m section without Use the velcro overlay to attach 2 roof sections 2nd Velcro to each other. Roofcover out 1st. Velcro Roofcover

8 8x12-2,6 PARTY TENT SEMI PRO, CombiTent I Select a flat ground for the tent, unpack the carton and check all the parts including tubes, tent and accessories etc. are present as same as list. Assemble the framework of rooftop by joining the portion ( ) together with poles (2.3).To ensure the screw fixed to every pole tightly II Attach one end of supported pole (.5) to the joints (8.11&9.12) Fastening the roof by using turnbuckle set(18) which is diagonally across through each two section as below.

9 8x12-2,6 PARTY TENT SEMI PRO, CombiTent III Cover the roof on the frame,and attach it by the bungee balls properly,take care of the tension of the bungee balls,for if you use too many on one side of tent,it may too tight to tie the other side of it.apply legs in one side as shown. IV Attach the another supported poles (6) to the joints (7.10), built-up the framework,use the long peg to fix each pole into the ground and connect leg cover with sidewall and endwall by Velcro as shown.using turnbuckle sets (17) to fasten the structure just the same as you do on roof

10 8x12-2,6 PARTY TENT SEMI PRO, CombiTent V spread the wall panel and door panel attach to framework by using the bungee cords clasping the frame to grommets that is construct over the wall panel and door panel to ensure stability. Also use the short pegs to fix the doors to the ground. VI The Guy lines clasp to each corner of tent and another end of line fix to ground by pegs.. Warning 1. In order to avoid being rusted by air, oil is covered on the surface of the pipes, before set up the tent, please remove the oil carefully frist to keep the cover clean. 2. Take note that the tent needs to be handled carefully to avoid damage. 3. Do not force the frame as they may be damage in the process.. Tents are meant as temporary shelter and must be evacuated under extreme weather conditions. Please select a suitable site for the tent to avoid the damage to underground sprinkler systems, water, gas or electrical lines.

11 Contact information Head office: Dancover A/S Nordre Strandvej 119 G 3150 Hellebæk Denmark For more information please visit: National contacts Denmark: denmark@dancover.com UK: uk@dancover.com Germany: germany@dancover.com France: france@dancover.com Sweden: sverige@dancover.com Finland: suomi@dancover.com Poland: polska@dancover.com Luxembourg: luxembourg@dancover.com Spain: espana@dancover.com Italy: italia@dancover.com Switzerland: schweiz@dancover.com Austria: austria@dancover.com Norway: norge@dancover.com Nederland: nederland@dancover.com Ireland: ireland@dancover.com Belgium: belgique@dancover.com Portugal: portugal@dancover.com Dancover (R) is a registered trademark of Dancover PLC.