Prtrv iding cioan DnnKlog Water to trw World ULTRAPURE 0.5m Ceramic Triple Bench Top City Water Filter with Fluoride Removal + Alkaline nstallation nstruction & Product Manual r m i t J i -4~ / L jf Mr
nstallation Diagram Quick & Easy DY nstallation Portable - deal for tliose renting i j STEP 1 Unscrew the existing aerator from the kitchen faucet STEP 2 For a male (external) threaded faucet, simply screw on the diverter valve. Hand tighten. See mage A n %MAGE A kl f your faucet thread is female (internal), first screw on the male adaptor provided, then the diverter. Hand tighten. See mage E %MAGE B
How to Flush the Fluoride Removal Cartridge Please follow these MPORTANT Steps below to ensure there will be no taste issues. So you will have the best tasting filtered water possible. i. Unpack your new w ater filter 2. Connect your water filter as required - DO NOT TURN ON THE WATER YET. 3. Remove all water filtration cartridges from inside your water filter after the Fluoride Removal Cartridge. Your Fluoride Removal Cartridge is normally installed into positions i or 2. (Take Care wrhen you are removing the ceramic cartridge. Please treat it like an Egg). 4. Turn on the water filter and check for leaks and ensure all is connected correcdy. 5. With the Fluoride Removal cartridge installed inside the water filter, with NO OTHER cartridges installed after the Fluoride removal cartridge, simply turn on the faucet and let it flush for at least 20 minutes. This water can he collected for the plants if so desired. 6. After flushing water through the Fluoride Removal Cartridge for 20 minutes, turn off the wtater supply and turn on the water filter faucet again to release any water pressure and dr ain. 7. Remove the housings for the cartridges you have removed and replace those cartridges into the positions they were in. 8. Tighten all housings, turn the water supply back on and check for leaks. 9. Turn on water filter and flush full system for a further 10 minutes. 10. After a further 12 hours turn on the faucet and flush the whole system for another 3 minutes, you are good to use your water filter.
nstalling Your ULTRAPURE 0.5m Ceramic Water Filtration Cartridge i. Clear any items out of the way to ensure you have a safe clear area to work, with no trip hazards or electricity that could create harm. 2. Turn off the water supply at the T-Piece up under the sink or the sink taps for a bench top model. 3. Turn on the faucet to release any water in the line which will remove the pressure on the water filter system. 4. Lay a towel down to soak up any excess water and to create a better surface to wrork from. 5. Once the pressure has vented from the system place the cartridge tool over the housing for the cartridge you want to replace. 6. With the correct posture in mind as required, turn the housing anti clockwise to crack the seal. Once the housing seal is loose you can simply unscrewr the housing by hand. (The ceramic cartridges can crack so please treat them like you would an eggl. 7. Remove the housing and throw away the old cartridge. You can wrash out the housing as required with 2 to 3 tablespoons of bleach or a sterilizer of your choice, flush well with water after doing so. 8. Remove the O-ring from the housing and wipe it clean, lightly lubricate the O-ring with silicon grease or olive oil. Replace the O-ring into the slot and press into place. 9. nsert the newr caruidge into the housing - For a under sink it says this way up.- For a bench top water filter, the end with the hole which says this way up goes dowrrl 10. Ensure the end of the ceramic cartridge with the open hole fits nicely into the housing cap standpipe, tighten securely with the housing tool.
11. Ensure you dry the housing and area surrounding then turn on the water supply slowly. Check for leaks, if no leaks the system is ready to move forward hut if you detect a leak repeat from above and fix the leak. 12. Turn on the water supply and flush the cartridge for 10 to 15 minutes, this water may he used on the garden. 13. After a further 12 hours flush again for a further 3 minutes and the water filter is good to he used. 14. For a cartridge containing carbon it is normal to see blackish water at first hut this will pass quite quickly, you may also find the first glasses of water may look quite milky, this is only oxygen that is released from the carbon which is perfectly safe to drink and will subside after a few days. 15. f you do not use your water filter for 5 days it is recommended that water he run to waste for 2 to 3 minutes before drinking. Extended Ceramic Cartridge Life Depending on the amoimt of sediment in your water and if you have sediment protection in front of the ceramic cartridge. e* if f the water flow slows dow n, you can simply scrub the ceramic cartridge under a running kitchen tap. Just use a f NEW green scourer pad or similar. Gently scrub the ceramic " cartridge under running water which will remove the sediment blocking the outside of the cartridge allowing a full flow again. Always wash your hands before and after cleaning a cartridge. Try not to touch the ceramic pan of the cartridge at all times. Website: www.mvwaterfilter.com.au Email: i rrfbgflmywaterfi ltercom.au Tel:1800 769 300 tslitwou