REPUBLIC OF INDONESIA MINISTRY OF TRANSPORT DIRECTORATE GENERAL OF CIVIL AVIATION. Certificate of Jlpprova[ Number: 145/56900

Similar documents
Certificate ofapprovac

Certificate of }fpprova{

~ir ~gencp (!Certificate

7.3 Operations Oversight Maintenance Oversight Prerequisites and Coordination Requirements 30

2A Document Evaluation for New Registered Aircraft List. 4. ISSUANCE CERTIFICATE OF REGISTRATION, DAAO FORM 47-02

The DAAO Inspectors should be thoroughly familiar with the regulatory and advisory references when using these instructions.

Operations Specifications

Staff Instruction SI Validation of a Foreign Aircraft Maintenance Engineer Licence. Amendment : Original D a t e : 4 April 2011

Operations Specifications

(1) Conforms to the R.I.-approved type design and is in a condition for safe operation (2) Has been subjected to a final operational check by the

NZQA unit standard version 3 Page 1 of 5. Apply knowledge of avionics to the certification of aeronautical maintenance

Operations Specifications

Operations Specifications

Operations Specifications

Aircraft Maintenance Prof. A.K Ghosh Prof. Vipul Mathur Department of Aerospace Engineering Indian Institute of Technology, Kanpur

Operations Specifications

Southwest Region Special Emphasis Item

Operations Specifications

STATUTORY INSTRUMENTS. S.I. No. 855 of 2004 IRISH AVIATION AUTHORITY (AIR TRAFFIC SERVICE SYSTEMS) ORDER, 2004

ASSEMBLY 35TH SESSION PLENARY. Statements by delegations of Contracting States and of Observers INDONESIAN AIRWORTHINESS SYSTEMS

Operations Specifications

Air Operator Certificate and Operations Specification format

Operations Specifications

Staff Instruction. SI Air Operator Certificate, Operating Certificate and Operations Specifications

NUMBER 008 PLACARDS AND MARKINGS (ATA 11) MAXIMUM ZERO FUEL GROSS WEIGHT - 48,000 POUNDS PLACARD INSTALLATION

Operations Specifications

Table of Contents. Pan A

TCAA-AC-AWS007C. March 2013 CERTIFICATION OF A FOREIGN APPPOVED MAINTENANCE ORGANISATION (AMO) 1.0 PURPOSE

REPUBLIC OF INDONESIA DEPARTMENT OF COMMUNICATIONS CIVIL AVIATION SAFETY REGULATION (CASR)

Airworthiness Directive Schedule

Operations Specifications

Air Agency Certificate

Operations Specifications

AIRWORTHINESS NOTICE

Operations Specifications

Operations Specifications

ICAO TECHNICAL COOPERATION PROJECTS IN INDONESIA to 2004

This certificate is issued to LUFTHANSA TECHNIK PHILIPPINES (LTP) whose primary address and contact information is:

Federal Aviation Regulations. Ric Peri VP Government & Industry Affairs Aircraft Electronics Association

Operations Specifications

AIRCRAFT SERVICE CHANGE

OVERSEAS TERRITORIES AVIATION REQUIREMENTS (OTARs)

Opspecs Revision status TABLE OF CONTENTS, LIST OF EFFECTIVE PAGES, AND RATINGS AUTHORITY. Page revision

IMPLEMENTATION PROCEDURES AIRWORTHINESS

REPUBLIC OF INDONESIA MINISTRY OF TRANSPORATIONS DIRECTORATE GENERAL OF CIVIL AVIATION JAKARTA INDONESIA

The DGCA should follow the appropriate procedures outlinedin paragraph 4002 of this order STATEMENT OF CONFORMITY, DAAO FORM

Part 406. Certification Procedures. (Effective December 29, 1960

REGULATIONS (10) FOREIGN AIR OPERATORS

SECTION TRAINING HELO. Date: 01/08/16 Page: 1 of Table of Contents Training, Helicopter

made under regulations and of the Civil Aviation Safety Regulations 1998.

Operations Specifications

Part 104 CAA Consolidation 1 March 2007 Gliders - Operating Rules

GUYANA CIVIL AVIATION REGULATION PART X- FOREIGN OPERATORS.

TABLE OF CONTENTS 1.0 INTRODUCTION...

Civil Aviation Authority of Nepal, Civil Aviation Regulation, 2058 (2002)

Operations Specifications

(Non-legislative acts) REGULATIONS

AUTOMATIC DEPENDENT SURVEILLANCE BROADCAST (ADS-B) IMPLEMENTATION IN INDONESIA

(i) Adopted or adapted airworthiness and environmental standards;

Airworthiness Directive Policy PO.CAP

NUMBER 903 RECORDING / INDICATING SYSTEMS (ATA 31) PLANEVIEW MASTER OPERATING SYSTEM SOFTWARE UPDATE

Administrator of Seoul Regional Office of Aviation

SI Airworthiness Certification of Aircraft And Related Product

STATUTORY INSTRUMENTS. S.I. No. 856 of 2004 IRISH AVIATION AUTHORITY (AIR TRAFFIC CONTROL STANDARDS) ORDER, 2004

Subpart H. 2042/2003

October 2007 ISSUE AND RENEWAL OF AIRCRAFT MAINTENANCE ENGINEER S LICENSE

EXPORT AIRWORTHINESS APPROVALS

Technical Arrangement on Aircraft Maintenance between the Transport Canada Civil Aviation Directorate and the Civil Aviation Authority of New Zealand

Advisory Circular. Canada and United States Bilateral Aviation Safety Agreement Maintenance Implementation Procedures

Operations Specifications

(b) Article means an aircraft, airframe, aircraft engine, propeller, appliance, or component part.

TCAA-AC-AWS021B. March 2014 ACCEPTANCE OF FOREIGN AIRWORTHINESS CODE FOR TYPE CERTIFICATE AND DATA SHEET 1.0 PURPOSE

Production Organisation Approval for Products, Parts and Appliances

AIRWORTHINESS ADVISORY CIRCULAR

Boeing 707. Overhaul & Repair Capabilities. USAerospacetn.com. U.S. Aerospace Corp. FAA Certified Part 145 Repair Station License USCR533K

Overseas Territories Aviation Circular OTAC Type Acceptance Certificates. United Kingdom. Issue 1 2 November Effective: On issue GENERAL

ULA IMPORT. 2. The application for an Israeli T.C. and the required documents are to be forwarded to:

Part 63 CAA Consolidation 22 June 2006 Flight Engineer Licences and Ratings

SERVICE BULLETIN. The equivalent of this service bulletin has been incorporated on production airplanes and On.

STATUTORY INSTRUMENTS. S.I. No. 420 of 1999 IRISH AVIATION AUTHORITY

GOVERNMENT OF INDIA OFFICE OF THE DIRECTOR GENERAL OF CIVIL AVIATION TECHNICAL CENTRE, OPP SAFDURJUNG AIRPORT, NEW DELHI

Advisory Circular. 1.1 Purpose Applicability Description of Changes... 2

GOVERNMENT OF INDIA OFFICE OF THE DIRECTOR GENERAL OF CIVIL AVIATION TECHNICAL CENTRE, OPP SAFDURJUNG AIRPORT, NEW DELHI

CCAR-129 XXXXX AIRLINES XXXX

Installation of Communication, Navigation, Radio and Radar Equipment.

AIRWORTHINESS ADVISORY CIRCULAR

~ir agtntp Q!:trtifitatt

Comparison on the Ways of Airworthiness Management of Civil Aircraft Design Organization

Airmen s Academic Examination

Continued Airworthiness Management under an Article 83bis Agreement - OTAR Part 39 Subpart F

Schedule 1 Units of Measurement Schedule 2 Voluntary Surrender of Licence

Advisory Circular. Trade Standards for Personnel Working in Approved Maintenance Organizations

COMMENT RESPONSE DOCUMENT (CRD)

GOVERNMENT OF INDIA OFFICE OF THE DIRECTOR GENERAL OF CIVIL AVIATION TECHNICAL CENTRE, OPP. SAFDARJUNG AIRPORT, NEW DELHI

GAC~ l)li.~aii (JI;.WJ.l iu I cw:..ej I G.enNal Au horlty ofcmi A ation

GUIDANCE MATERIAL Designated Engineering Representatives (Authorised Persons)

GUERNSEY AVIATION REQUIREMENTS. (GARs) CONTINUING AIRWORTHINESS PART 39 REQUIREMENTS

UNITED STATES OF AMER ICA DEPARTMENT OF TRANSPORTATI ON * FEDERAL AVIATION ADM 1 N I STRATION. tteccecl/ /o' LEE AIR COMPANY, INC.

DIRECTORS GENERAL OF CIVIL AVIATION CONFERENCE ON A GLOBAL STRATEGY FOR AVIATION SAFETY

VFR GENERAL AVIATION FLIGHT OPERATION

Transcription:

REPUBLIC OF INDONESIA DAAO Form 145-2 MINISTRY OF TRANSPORT Certificate of Jlpprova[ Number: 145/56900 This certificate is issued to 1: Whose business addresses is r~ = '.... Location of faciliti: s 0 ~---. ~ l INERTIAL AIRLINES SERVICE, INC. DBA INERTIAL AEROSPACE SERVICES, INC. 375 ALPHA PARK DRIVE HIGHLAND HEIGHTS, OHIO - 44143, USA 375 ALPHA PARK DRIVE HIGHLAND HEIGHTS, OHIO- 44143 USA Upon finding that this organization complies in all respecteds \vith the requirements of the Civil Aviation Safety Regulations relating to the establishment of an approved organization, and is empowered to operate as an: I APPROVED MAINTENANCE ORGANIZATION With the following ratings ' > Instruments Radio Limited Specialized As specified in Operations No. \l l J P - This approval is not transferable and shall continue in effect for a period of two (2) years from the date of issuance unless cancelled, suspended or revoked by the Director General, and any major change in the basic facilities, or in the location thereof, shall be immediately reported to the Director General. eneral of Civil Aviation Date of issuance August 16, 2016

.. MINISTRY OF TRANSPORTATION I. CONDITIONS 1. Operation of the Approval Maintenance Organization within the scope of this Certificate of Approval is subject to all applicable requirements of Parts 145 of Civil Aviation Safety Regulations (CASR). 2. The Accountable Manager, on behalf of the organization, shall be responsible to the Director General of Civil Aviation for ensuring a satisfactory standard of operation of the organization. 3. An Organization with a Limited Rating shall maintain a document containing detailed information regarding its capability for performing maintenance and alteration in accordance with applicable airworthiness requirements, and the type of the work the organization is capable of performing on aeronautical products. The document shall be in form of Capability List, and shall include complete data relating to, as applicable, the make, model, part name and part number for each aeronautical product within the organization's scope of approval. 4. All work within the scope of this approval must be performed in compliance with all specified requirements for the housing, facilities, equipment, tools, material, technical data, processes, and personnel. 5. All work performed within the scope of this approval to an Indonesian registered aircraft shall be reported to the Directorate General of Civil Aviation in the form of a quarterly report. Reports may be mailed to the Directorate of Airworthiness and Aircraft Operation 22nd Floor, Gedung Karya, JI. Medan Merdeka Barat No. 8 Jakarta Pusat 10110 - Indonesia. Page 1of4

MINISTRY OF TRANSPORTATION II. SCOPE OF APPROVAL 1. Rating: INSTRUMENT CLASS 1, 2, 3 and 4: INTRUMENT CLASS 1 - Mechanical INTRUMENT CLASS 2 - Electrical INTRUMENT CLASS 3 - Gyroscopic INTRUMENT CLASS 4 - Electronic Radio Class 2: Navigational Equipment: Manufacturer 2. Limited Ratings: - Specialized : Make/Model LTN-2001 (MK-1) GPSSU PIN 465205-XXXX-XXXX L TN-2001 (MK-2) GPSSU PIN 466200-:XXXX-XXXX LTN-2012 GPS PIN 465880-010000101 Maintenance and return to service Specification 10669M. Specification 10372RM. Specification 10882PM. Honeywell Integrated Switch Panel Touch Assembly Panel PIN 4073972-3,-301,-4,- 401,-5 thru-10, and IDD Aerospace 3LP20-3,-4,865-000103-3 thru -6,-9,-10 Honeywell Gyro Spare Kits PIN 10095212-XXX: as identified in 10372RM Goodrich Fuel Quantity Indicator Display PIN 10080-1800-XXX as identified in 10882PM. Page 2of4

as identified in 10882PM. MINISTRY OF TRANSPORTATION Specification 28-42-02-01. Specification 28-42-02-01. Specification 10971PM. Specification 11004PM. Specification 11034PM. Specification l l l 76PM. Specification 28-42-02-03. Specification 11206PM. Goodrich Fuel Quantity Indicator PIN 10030-1000-015lto -0166 Goodrich Fuel Quantity Indicator PIN 10030-1000-0151to -0166 Module PIN's 2302430-1and67109-101. Goodrich Fuel Quantity Indicator End Cap Assembly PIN's 10037-1500-0750, - 0751and -0770 Goodrich Fuel Quantity Indicator End Cap Assembly PIN's 10037-1500-0750, -0751 and-0770 Reprogramming of Flash Memory for Honeywell HG2950AC02-AC11 A3 PIN 26015235-402 and A4 PIN 26016610-101 circuit card assemblies Goodrich Interconnect Assembly PIN 10037-0408-01 Module PIN's 10037-0750 and 10037-0770 Page 3of4

MINISTRY OF TRANSPORTATION Repair and Return to Service Repair and Return to Service Specification I 1204PM. Specification 11222PM. Specification 10093RM. Specification I l 164RM. Module PIN's 10080-0403,-404 and 10080-1800-0504,-0505. Programming procedures for Honeywell HG1050 Al CCA. Honeywell part numbers 26012875-:XXX and 266804- :XXX circuit card assemblies EPROM CHIPS Procedure for Fuel Quntity Housing Assembly PIN 10037-1300-0770 cover glass replacement Procedure for Fuel Quntity Husing Assembly PIN 10037-1300-0770 cover glass replacement CC: The Director General of Civil Aviation Page 4of4