Electrical Specifications. Input range Vac (Operating) 115/230 Vac (Nominal) Internal fuse on both L and N lines.

Size: px

Start display at page:

Download "Electrical Specifications. Input range Vac (Operating) 115/230 Vac (Nominal) Internal fuse on both L and N lines."

Anabel Mason
5 years ago
Views:

POWER Data Sheet L Watts onvection/onduction Mounting Total Power: W # of Outputs: Single Outputs: 1,, 8 V Special features W full power at elevated temperatures Wide operating temperature range

Immunity MIL-STD-1E: E11; E1; S11; S11 SFETY UL + S TÜV 9-1 nd Ed. NSI ES1-1 3rd Ed 9-1 nd Ed. 1-1 3rd Ed.

1 POWER Data Sheet L Watts onvection/onduction Mounting Total Power: W # of Outputs: Single Outputs: 1,, 8 V Special features W full power at elevated temperatures Wide operating temperature range suited for outdoor application IP rated onduction-cooled or convection Differential remote sense Output adjust Output On/Off (Positive or Negative logic user selectable) ompliance EMI lass EN1 Immunity MIL-STD-1E: E11; E1; S11; S11 SFETY UL + S TÜV 9-1 nd Ed. NSI ES1-1 3rd Ed 9-1 nd Ed rd Ed ; -13 Scheme IE 9-1 nd Ed IE 137-1; -13 IE 1-1 hina E Mark Electrical Specifications Input Input range 9 - Vac (Operating) 11/3 Vac (Nominal) Frequency 7-3 Hz Input fusing Internal fuse on both L and N lines Inrush current Power factor >.9 Full load Harmonics Meets EN1-3-; MIL-STD-1E () ; E11; E1; S11; S1 Input current 9 Vac full load Hold up time 1 ms minimum at 11 Vac; 1% load Efficiency 3 Vac; 1% load 1 V - 89% typical V - 91% typical 8 V - 91.% typical Leakage current < 7 μ at 3 Vac

L Data Sheet Electrical Specifications Output Output rating 1 V @.8 V @ 1. 8 V @. Set point ±.

2 L Data Sheet Electrical Specifications Output Output rating Set point ±.% Factory set point Total regulation range ±% Line/Load/Temperature Rated load W maximum Minimum load Load No loss of regulation apacitive load - 33 μf/mp Output voltage overshoot No overshoot/undershoot outside the regulation band during on or off cycle onstant output voltage adjustment range 1 V: +1 / -1% djust via VR V: +1. / -1% 8 V: +1% / -1% onstant output current adjustment range + / -% djust via VR1 mode supported from Vo nominal down to 8% Vo Output ripple and noise 1 % to 33 μf/mp Transient response ±% Vo max transient; recovery < μs max % Load 1 /μs Step Load verified at: % to 1% Load; 9 - Vac input; apacitive load from to 33 μf/mp Remote sense apable of Stable Offset of ±. Vdc at output +SENSE (Red Wire); -SENSE (lack Wire) cable termination Output On/Off Remote On/Off referenced to secondary side. On/Off (Orange Wire); On/Off Return (White Wire) Positive or Negative logic user selectable via N. Factory default is Positive logic Overcurrent protection (OP) 1% Io uto-recovery Overvoltage protection (OVP) 11% to 13% Vo Latching mode; Requires input recycle Overtemperature protection (OTP) uto-recovery; hiccup mode Output isolation 3 Vac Input to Output 1 Vac Input to Ground Vac Output to Ground Environmental Specifications Operating temperature Storage temperature - to +8 Humidity ltitude Shock Vibration Ingress protection MTF (calculated) Suffix P (onduction): - to +8 aseplate Temperature Suffix 7P (onvection): - to +8 mbient Temperature 1% to 1% (ondensing & Non-ondensing) Operating: 13, feet Non-Operating:, feet IE8--7 IE8-- / IE71-3- IP Rated > 78, hours at 1% load; Low line; Telcordia SR-33

3 L Data Sheet Ordering Information Output urrent Output Ripple Line/ Model Number Output djustment Range Min Max P/P 1 Load Regulation L-1U-P 1 V ±1%.8 1% ±% L-1U-PE 1 V ±1%.8 1% ±% L-1U-7P 1 V ±1%.8 1% ±% L-1U-7PE 1 V ±1%.8 1% ±% L-U-P V +1. / -1% 1. 1% 3 ±% L-U-PE V +1. / -1% 1. 1% 3 ±% L-U-7P V +1. / -1% 1. 1% 3 ±% L-U-7PE V +1. / -1% 1. 1% 3 ±% L-8U-P 8 V ±1%. 1% ±% L-8U-PE 8 V ±1%. 1% ±% L-8U-7P 8 V ±1%. 1% ±% L-8U-7PE 8 V ±1%. 1% ±% 1. Output ripple measured at the end of the output cable terminated with 1 μf tantalum cap in parallel with.1 μf ceramic capacitor.. 1 V: 1% limit is achieved with X 8 uf/1 V external cap (e.g. PLG181MDO1 from Nichicon or equivalent). Otherwise, maximum limits are 1.% at Ta and.% max at Ta <. 3. V: 1% limit is achieved with X 8 uf/3 V external cap (e.g. UPM1V81MHD1TO from Nichicon or equivalent). Otherwise, maximum limits are 1.% at Ta -1..% max ripple at Ta < -1 is met with below external capacitance: mbient Temperature ( ) Recommended External apacitors (μf) V: 1% limit is achieved with 3X 7 uf/3 V external cap. Otherwise, maximum limits are 1.% max at Ta and % max at Ta <.. Two () L model numbers exist with same electrical performance except for safety approvals as shown below: L-XXu-xPE version = Europe/hina safety approved & carries E/TÜV & logos L-XXu-xP version = Europe/US safety approved & carries E/TÜV & cul logos. 1 V unit requires external filtering for MIL-STD-1E compliance. onsult rtesyn Technical Support. 7. Warranty: years

4 L Data Sheet Output urrent () L-1U-P (onduction) 11/18/3 Vac 1 3 Vac 1 18 Vac 11 Vac 9 Vac aseplate Temperature ( ) Output urrent () 1 1 L-1U-7P (onvection) = 11 Vac NT ONV 1 LFM LFM 3 LFM LFM mbient Temperature ( ) Fig 1. 1 V P Suffix (onduction) Output urrent Derating Fig. 1 V 7P Suffix (onvection) Output urrent Derating at 11 Vac L-1U-7P (onduction) = 3 Vac 9% 9% 1V Efficiency vs. Input Line Output urrent () 1 1 NT ONV 1 LFM LFM 3 LFM LFM mbient Temperature ( ) Efficiency (%) 8% 8% 7% Vin = 11 Vac 7% Vin = 3 Vac % % % % % 8% 1% Output Load Fig 3. 1 V 7P Suffix (onvection) Output urrent Derating at 3 Vac Fig. 1 V Efficiency urve Output current () L-U-P (onduction) Vac 11 Vac 3 Vac Vac aseplate Temperature ( ) Output urrent () L-U-7P (onvection) = 11 Vac NT ONV 1 LFM LFM 3 LFM LFM mbient Temperature ( ) Fig. V P Suffix (onduction) Output urrent Derating Fig. V 7P Suffix (onvection) Output urrent Derating at 11 Vac

5 L Data Sheet L-U-7P (onvection) = 3 Vac 9 V Efficiency vs. Input Line 1 9 Output urrent () 1 8 NT ONV 1 LFM LFM 3 LFM LFM Efficiency (%) Vac 3 Vac mbient Temperature ( ) Output Load (%) Fig 7. V 7P Suffix (onvection) Output urrent Derating at 3 Vac Fig 8. V Efficiency urve L-8U-P (onduction) L-8U-7P (onvection) = 11 Vac Output urrent () Vac 11 Vac 3 Vac Vac Output urrent () 3 1 NT ONV 1 LFM LFM 3 LFM LFM aseplate Temperature ( ) mbient Temperature ( ) Fig 9. 8 V P Suffix (onduction) Output urrent Derating Fig 1. 8 V 7P Suffix (onvection) Output L-8U-7P (onvection) = 3 Vac 9 8 V Efficiency vs. Input Line 9 Output urrent () 3 1 NT ONV 1 LFM LFM 3 LFM LFM Efficiency (%) Vin=11 Vac Vin=3 Vac mbient Temperature ( ) 8 1 Output Load (%) Fig V 7P Suffix (onvection) Output urrent Derating at 3 Vac Fig 1. 8 V Efficiency urve

6 L Data Sheet Mechanical Drawings 1 V MODEL LEL L1 INPUT POTTING TRIM LEL -Ø 3. ±.1 L D OUTPUT ( - 3.) ( ) 11. ±. L3 ONTROL M ( - 9.7) ( ) ( ) ( ) 177. ±. USHING (See DETIL ) DJUST DIMMING (VR1) DJUST REMOTE ON/OFF (N) SEE DETIL VIEW M DJUST OUTPUT VOLTGE (VR) 7.9 ±. L-1U-P ON (NEGTIVE POLRITY).3 SERIL NO. RODE LEL OFF (POSITIVE POLRITY) 37. ±. L-1U-7P DETIL V / 8 V MODEL LEL L1 INPUT POTTING TRIM LEL -Ø 3. ±.1 L D OUTPUT ( - 3.) ( ) 11. ±. L3 ONTROL ( - 9.7) ( ) ( ) ( ) 177. ±. USHING See DETIL vailable Mounting Holes for -7P Suffix (with Heatsink) 7.9 ±. L-xxU-P 37. ±. L-xxU-7P SERIL NO. RODE LEL (FOR PE/7PE ONLY).3 Mounting Hole X locations (Top over Side) #-3 thread Mounting Hole X locations (Top over Side) M3X. thread For both and Mounting Holes, screw length should be <.mm/torque 8KG-F Max. DETIL

7 L Data Sheet able Length Designation Wire olor Wire Gauge Input able L1 = 3 ±1 mm L = Live rown WG#18 N = Neutral lue WG#18 PE = Primary Earth Green/Yellow WG#18 D Output able L = 3 ±1 mm +Output lue WG#1 -Output Gray WG#1 ontrol able L3 = 3 ±1 mm Dimming rown WG# Dimming Return Yellow WG# ON/OFF Orange WG# ON/OFF Return White WG# Sense Red WG# Sense Return lack WG# WORLDWIDE OFFIES mericas 9 S.Diablo Way Tempe, Z 88 US Europe (UK) Waterfront usiness Park Merry Hill, Dudley West Midlands, DY 1LX United Kingdom + () sia (HK) 1/F, Lu Plaza Wing Yip Street Kwun Tong, Kowloon Hong Kong rtesyn Embedded Technologies, rtesyn and the rtesyn Embedded Technologies logo are trademarks and service marks of rtesyn Embedded Technologies, Inc. ll other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. Specifications are subject to change without notice. 18 rtesyn Embedded Technologies, Inc. ll rights reserved. For full legal terms and conditions, please visit For more information: For support: productsupport.ep@artesyn.com L DS 9ug18

Power Supplies 3. SVL Essential DIN Rail Series. Phone: Fax: Web: -

Power Supplies 3. SVL Essential DIN Rail Series. Phone: Fax: Web: - SVL Essential DIN Rail Series SVL Series power supplies are perfect for high volume, controlled environment applications where essential features are the only requirement. When space inside an enclosure