WEIGHING Series (JXW) (JXW) User s Manual - 0 -

Transcription

1 WEIGHING Series (JXW) (JXW) User s Manual - 0 -

2 1.Perface erface: Build uild-up up drawing: Instruction Attention ttention: Measure unit: Panel and key: Simple counting setting MODE % Upper & Lower limit calibration Digits calibration: Uncorrect message

3 1 Perface Thank you for using our products, it has high-precision analytical capacity; show the weight prompt, constancy, exactitude, simple operation, can be help for manufacturer of electronic, hardware, plastic, medicinal and textile to received and dispatch the goods, package, admeasure, counting and control the production weight; it is saved-time, saved-power, saved-money, and saved-material, reduce the cost, and improve the efficiency, to up to the highest interest. 2 Build uild-up up drawing 2 3 Instruction:--- 1 Hold switch 2 AC Power source supply lines 3 shipping protection screw 4 Attention: full charge the battery after unpacking the scale 2. *recharge the battery*:when battery symbol appears on the LCD display, please plug in the power lord to charge the battery. The indicator of charge will light up in red. When it becomes green means charge completed.( it takes about 8 hours to full recharge the battery) 3. install the equipment on a level and stable surface. 4. do not install the equipment near the air condition or a vibrating machine. 5. please in the temperature of 0 ~ 40, prevent from rapid temperature changes 6. independent AC outlet for this equipment is recommended, check the voltage before plug in. 7. warm up the equipment for 15 minutes before use - 2 -

4 5 Unit conversion: kg = 1000g 2. 1 lb = g 3. 1 oz = g 4. 1 tj = kg 6 The panel and key H-L MODE + T O - UNIT > key instruction O To come into ZERO UNIT T When weight on pan, press this key to do TARE charge panel instruction MODE For units switch; when in pcs or % mode, for doing sample For weighing, sample, % switch connect with the adapter,if the charge light is red,it means the scale is charging.if the light is green,it means the battery is full,no need to charge. 6-1 simple counting setting: Press MODE,choose the PCS,Put the goods Press UNIT,enter into quantity setting - 3 -

5 Press MODE,saving the above setting, you can begin to use this function 6-2 mode % Press MODE,choose the % Press UNIT,Put the goods Press MODE,saving the above setting, you can begin to use this function 6-3 upper and lower limit calibration setting: Long press MODE 3 seconds,enter into alarm -H-L- Press UNIT,The circulation cut must sound the sector (H upper limit, L lower limit, - Twinkle The sector sounds the position) -H-L- Press MODE,enter into upper limit setting - 4 -

6 Press MODE,enter into lower limit setting Press MODE,saving the above setting, you can begin to use this function 6-4 Digits calibration:(pays attention to ~ essential to have the standard weight only then to be possible to use this function) Long press TARE 3 seconds,enter digits calibration Puts the weights (to with the above hypothesis same weight weights, the example: 1KG) Waited for that the left side mark appears the latter 3 seconds Press MODE,Appears sounds short B, indicated that adjusts successfully. (for example calls B one, expression adjustment defeat for Changming) 7 Uncorrect message: uncorrect message Our---- Lo-bAt reason Over the load, please take it away at once. When the light of low battery voltage appears, please charging at once - 5 -

7 /07/17