King Canopy Item # SG1324S

Transcription

1 PLS R TH INSTRUTIONS OR PROING TO SSML THIS NOPY StorGuard 13 ft x 24 ft 13 ft 7 in Wide (ottom) 11 ft 5 in Wide (Top) x 24 ft Length 6 ft 7 in Side Height / 8 ft 9 in enter Height / 6 ft 10 in oor Height King anopy Item # SG1324S With 10 Legs, over with Side Walls, 2 nd Walls, Rafter races, lastic all Straps, oot Pads and nchors. These Tools re Recommended: istributed by: PI merica, LT Purfoy Road uquay-varina, N WRNING: Keep all flame and heat sources away from this tent fabric. The fabric will burn if left in continuous contact with any flame source.

2 PRTS LIST 3X4-2PS-T- 30 pc 2X0-2PS-T- 10 pc 2 x39.5 Silver Swage Pipe 2 x23.75 White Swage Pipe 2X9PS-T- 20 pc x32.5 Silver Pipe 3X4PS-T- 20 pc x39.75 Silver Swage Pipe 3X6-1PSS- 5 pc 1 x42 Rafter race Pipe w/swage 3X6-1PS- 5 pc 1 x42 Rafter race Pipe 3W2PS-T-R 2 pc 3-way onnectors - Right Side 3W2PS-T-L 2 pc 3-way onnectors - Left Side 3W215P-T 2 pc 3-way onnectors - (Peak nds) R Peak L 4W2PS-T 6 pc 4-way onnectors - (Sides) 4W215P-T 3 pc 4-way onnectors - (Peak) Peak S215-T 4 pc 3-way lamp 215-T 6 pc 4-way lamp 10 pc 5/16 x 2 1/2 olts 16 pc 5/16 x 2 lamp olts 5 pc 5/16 x 1 1/2 olts 31 pc 5/16 Nuts & Washers LL 75 pc lastic all Straps SG1324S 1 pc itted 1 Piece over SG13SW 2 pc nd Walls with Grommets OOT2PS-T 10 pc Slanted oot Pads pc nchors with able & U-lamp SGSHOOKS 20 pc S Hooks (4 Sets of 5) S SGWR 8 pc nd Wall Rings (2 Sets of 4)

3 PRTS LIST

4 ROO RM SSMLY Step Separate all pieces for the roof section first according to size and shape and arrange per the illustration shown below. Left orner L R Right orner Right orner Step Start with the center and complete the center frame first. Then assemble each side. You will be using the 5/16 x2 1/2 bolts and nuts for the roof frame assembly. Make sure the bolt holes in the pipes are aligned and insert bolts on the ends with the rounded head facing the cover so they do not make contact with the cover and puncture it. lso at this point you will need to install the cross braces at each roof truss section and using the 1 1/2 bolt to join them together at the center. Install them with the round head at the top to so the end walls can slide easily over them without getting stuck. 5/16 x2 1/2 R Right orner R L Left orner Left orner L 5/16 x1 1/2

5 OVR SSMLY rape the cover over the the roof frame with the grommets on the bottom facing the roof frame and attach with ball bungees at each end. You may want to fold the sidewall section back onto the roof frame to keep it out of your way off the ground until you attach the legs. The sidewalls are long enough to be buried in the ground to prevent water from running inside. Inside View Outside View

6 OVR & LG SSMLY ONNT TH LG POLS TO TH ROO SSMLY. Step irst insert the pipes (Parts & ) for the middle poles into the 3 and 4-way connectors, and then connect the end leg pipes in the same way. o the same for the other side. Push the foot pads onto the bottom of each leg. (See illustration) NOT: The foot pads are NOT for anchoring the canopy! Insert Second Insert irst Step Now slide the bottom rails through the pockets at the bottom of the sidewalls and attach using the 3 and 4-way clamps and 2 clamp bolts and wing nuts. 5/16 x2 5/16 x2 IMPORTNT! Once the legs and cover are assembled, your canopy will act like a kite in the wind. It is imperative that the canopy anchors be installed NOW!

7 N WLL SSMLY TTH N WLLS TO ROO R RS. Step Loosen 1 end of the brace support bar and slide 4 rings onto the bar. Step Hook the endwall onto each ring through the grommets on the top edge of the end wall. Step ttach an S-hook to the cover and with some pliers you may squeeze the end of the S-hook tight to prevent it from coming loose. Step Loop a ball bungee strap through the grommet on the side wall and pull it over the side and hook it into the S-hook to secure the end wall in a closed position. Step To open the end, unhook all the ball bungees from one side and slide the wall open.

8 NHORING YOUR UNIT This canopy is designed for use as a temporary structure. fter assembly, the canopy MUST securely anchored to the ground to prevent damage from winds. Your canopy will act like a kite in the wind if not properly and securely anchored to the ground. Severe winds will cause the frame to twist and unanchored legs will fall, thereby collapsing the canopy. If severe winds are expected, you must remove the cover from the frame to prevent damage. We recommend anchoring your canopy at each corner foot and center foot on each side. Screw anchor into ground next to canopy foot using a large screw driver (1). Looping the cable through the anchor eye will keep it out of the way while turning. Tilting the anchor slightly will help the anchor to cut into the ground. pply downward pressure while turning the anchor into the ground. Leave approximately three inches of anchor out of the ground. Unloop the cable from the anchor eye and slide the clamp onto cable (2). Run cable around the pipe, and then back through the clamp. Pull the cable as tight as possible through the clamp. Hold the cable and tighten clamp with an adjustable wrench. When you have tightened the clamp and satisfied that the cable will not slip, you may tighten the cable more by turning the anchor further in the ground as seen in iagram (1). (2) (1)

9 IMPORTNT NOTI: PLS R RULLY We are confident that you will be completely satisfied with your King anopy unit. Please take a moment to read the very important information below, and call us with any questions you may have. King anopy/pi merica, LT. has no control over wind, snow, ice, rain or any other weather condition and we are in no way responsible for any damage caused by the canopy or to the canopy. We suggest you contact your insurance carrier just as you would for any other outside structure. OTHR PRUTIONS WHIH MUST OLLOW: Keep all flame and heat sources away from this tent fabric. The tent fabric will burn if left in continuous contact with any flame source. O NOT cook underneath or near canopy. O NOT store or use flammable liquids underneath or near canopy. O NOT ignite or store fireworks underneath or near canopy. O NOT use bleach to clean cover. O NOT dry clean cover. O NOT wash cover in washing machine or dry in dryer. Hand wash with mild soap and water only. O NOT allow rain water, snow or ice to accumulate on top of cover. O NOT hang or suspend anything from the frame, grommets, truss system or ball straps of the unit. RMOV canopy cover before a storm, or disassemble entire canopy unit if possible. RMOV rain water, snow and ice from canopy cover. This is a temporary structure and is not recommended for use as a permanent structure. The King anopy StorGuard Garages are designed to be one of the strongest and most well designed garages in production today. This innovative product offers numerous features and benefits for the end use consumer. Key features include a commercial grade P fabric skylight that allows sunlight to enter and Pass-Thru front and rear doors that make storing automobiles, boats, TVs or personal watercraft a breeze! The Roof Truss System is included for increased stability and durability in extreme weather conditions and able to withstand significantly heavier loads than frame systems that do not include this outstanding feature. asy to assemble and engineered for maximum protection. Includes one year limited warranty. (Please see enclosed instruction sheet for details.) ***The Roof Truss System will not guarantee that your King anopy Garage/arport will hold heavy loads (snow specifically) indefinitely. ny significant snow accumulation must be removed frequently to avoid the possibility of P fabric failure and steel frame collapse.***

10 PROUT INORMTION Missing/efective Parts We try our best to eliminate any defective parts that are shipped with our products. arefully inspect all packages upon arrival and report any missing or defective items upon receipt. ny discrepancies must be reported to King anopy within 30 days of purchase. Please be sure to take a few minutes to match all items in the box to the items on the product manual. If there should be any missing or defective items, we will ship them free of charge. You will need to fill out a warranty claim form and , fax, or mail it in along with a proof of purchase showing date of purchase. Your replacement will be shipped free of charge by ground shipping. Next day or express shipping will require freight collect and paid for by you. amages from improper anchoring, strong winds, snow, ice or rain are not considered defects. 1 Year Limited Warranty ll of our canopy components feature a 1-year limited warranty (90 day-limited on Value King rand items) and are warranted to be free from defects in material and workmanship during this time frame. You must fill out our warranty claim form and provide your proof of purchase receipt. This does not pertain to any missing or defective parts in the 30 day inspection period. efective Returns If you receive a product that is defective and wish to return it, please contact our customer service department to receive a return authorization number. ll items will be passed through quality control before issuing a credit. You will be contacted upon receipt of your returned merchandise and notified whether your return is accepted or not. If not, you will have the option to receive the product back at your expense. Improper nchoring, Strong Winds, Rain, Snow, or Ice King anopy/ PI merica, LT. does not guarantee these canopies under strong weather conditions (including snow and ice) under any circumstances. These canopies are designed to protect against damages cause by sun, light rain, tree sap, birds, etc. They are not designed to hold roof loads that accompany snow, ice, or heavy rains. If your canopy is not anchored securely, strong winds can lift it and cause damage if it is blown over and/or away. anopies make excellent kites. If your canopy is anchored incorrectly and is blown away, we will not send any free replacement parts for damages. If you know strong weather is predicted, remove the cover or take down the unit completely. The cover is designed to be quickly and easily removed. Non-Warranty Replacement Parts If your warranty expires and you need replacement parts and they cannot be found on please contact us at We stock replacement parts for most of our products. Our customer service department will be pleased to assist you in any way possible. ertain regions of the country are extremely harsh on canopy covers. Normal wear and tear is not covered under warranty, and should be expected. In order to receive a discounted or free replacement part, you may be asked to return the part, freight prepaid, to our warehouse for inspection before we will send a replacement. You must, in all cases, provide a copy of your receipt showing the date of purchase, model number and price. ustomer Service: 8:00 M 5:00 PM ST, Monday - riday Toll ree: ax: ownload Warranty laim orm from our website. Return Policy ll returns will require a return authorization number (R). To obtain an R, please contact our customer service department at (800) ll returns must be submitted within 30 days of purchase date, located on receipt. ny returns summited after 30 days without an R number will not be accepted. redit will be issued upon receipt of product and inspected for damages or excessive wear and tear. The full amount of the product will be credited in the form of original payment minus a 15% restocking fee and shipping and handling. *Please allow time to inspect and issue the appropriate refund.* ustomer Service: 8:00 M 5:00 PM ST, Monday - riday Toll ree: ax: returns@kingcanopy.com