En-route procedures VFR

Transcription

1 anoeuvres/procedures Section Pre-flight including: Documentation, mass and balance, weather briefing, NOTA FTD FFS A Instructor initials when training 1.2 Pre-start checks External P# P Internal P 1.3 Engine starting: Normal alfunctions P 1.4 Taxiing P Pre-departure checks: Engine run-up (if applicable) P Take - off procedure: P Normal with Flight anual flap settings Crosswind (if conditions available) Climbing: Vx/Vy Turns onto the headings, level off P 1.8 ATC liaison - Compliance - R/T procedures Section Straight and level flight at various airspeeds including flight at critically low airspeed with and without flaps. (including approach to VCA when applicable) Steep turns (360 left and right at 45 bank) Stalls and recovery: (i) clean stall (ii) Approach to stall in descending turn with bank with approach configuration and power (iii) Approach to stall in landing configuration and power (iv) Approach to stall, climbing turn with take-off flap and climb power (single engine aeroplane only) Handling using autopilot and flight director (may be conducted in section 3), if applicable P Chkd FFS A P P P 2.5 ATC liaison - Compliance - R/T procedures Section 3A 3A.1 Flight plan, dead reckoning and map reading 3A.2 aintenance of altitude, heading and speed 3A.3 Orientation, timing and navigation aids (if applicable) 3A.4 Use of radio navigation aids (if applicable) 3A.5 Flight management (flight log, routine checks including fuel, systems and icing) Departure Airwork (VC) En-route procedures VFR LIC-FR-381 Rev.No. 0/ EXT-PUB Page 1/3:

2 anoeuvres/procedures 3A.6 ATC liaison - Compliance - R/T procedures FTD FFS A Instructor initials when training Section 3B 3B.1 Departure IFR P 3B.2 En-route IFR P 3B.3 Holding Procedures P 3B.4* 3D operations to DH/A of 200 feet (60 m) or to higher minima if required by the approach procedure (autopilot may be used to the final approach segment vertical path intercept) Chkd FFS A P 3B.5* 2D operations to DH/A P 3B.6* Flight exercises including simulated failure of the compass and attitude indicator: Rate 1 turns; Recoveries from unusual attitudes P 3B.7* Failure of localiser or glideslope P 3B.8* ATC liaison - Compliance - R/T procedures Section Aerodrome arrival procedure P 4.2 Normal landing P 4,3 Flapless landing P 4.4 Crosswind landing (if suitable conditions) P 4.5 Approach and landing with idle power from up to 2000' above the runway (single engine aeroplane only) P Instrument flight Arrival and landings 4.6 Go-around from minimum height P 4.7 Night go-around and landing (if applicable) P 4.8 ATC liaison - Compliance - R/T procedures Section 5 Abnormal and emergency procedures This section may be combined with sections 1 trough Rejected take-off at a reasonable speed P 5.2 Simulated engine failure after take-off (single-engine aeroplanes only) 5.3 Simulated forced landing without power (single-engine aeroplanes only) 5,4 Simulated emergencies: (i) Fire or smoke in flight (ii) Systems' malfunctions as appropriate P P P 5.5 Engine shutdown and restart (E skill test) P 5.6 ATC liaison - Compliance - R/T procedures Section 6 Simulated asymetric flight This section may be combined with sections 1 trough 5 6.1* Simulated engine failure during take-off (at a safe altitude unless carried out in FFS or FNPT II) P X LIC-FR-381 Rev.No. 0/ EXT-PUB Page 2/3:

3 anoeuvres/procedures 6.2 Asymmetric approach and go-around procedure Instructor initials Chkd when training FFS FTD FFS A A P 6.3* Asymmetric approach and full stop landing P 6.4 ATC liaison - Compliance - R/T procedures The following symbols mean: (*) the starred items shall be flown solely by reference to instruments. If this condition is not met during the ST or PC, the type rating will be restricted to VFR only. = mandatory exercise A = aeroplane FFS = Full Flight Simulator FTD = Flight Training Device P = Trained as PIC or Co-pilot and PF and PNF for the issue of a type rating as applicable X = Simulators shall be used for this exercise, if available, otherwise an aircraft shall be used if appropriate for the manoeuvre or procedure P# = The training shall be complemented by supervised aeroplane inspection The practical training shall be conducted at least at the training equipment level shown as (P), or may be conducted up to any higher equipment level shown by the arrow ( >) LIC-FR-381 Rev.No. 0/ EXT-PUB Page 3/3:

4 APPLICATION AND REPORT FOR FOR ATPL, PL, TPYE RATING, CLASS RATING SKILL TEST AND PROFICIENCY CHECK Aeroplanes and helicopters APPLICATION AND REPORT FOR FOR ATPL, PL, TPYE RATING, CLASS RATING SKILL TEST AND PROFICIENCY CHECK Aeroplanes and helicopters Applicant s last name: SE-SP: A H E-SP:A H Aircraft: Applicant s first name: SE-P: A H E-P: A H of applicant: Operations: SP P Type of license held Checklist: Training record Type rating: License number: Skill test: Class rating: IR: State of license issue: Proficiecy check: ATPL: PL: 1 Theoretical training for the issue of a type or class rating performed during period From: To: At: Pass mark: of HT: Type and number of licence: (s) in capital letters: 2 FSTD FSTD (aircraft type) Three or more axes: Yes No Ready for service and used: FSTD manufacturer otion or system: Visual aid: Yes No FSTD operator FSTD ID code: Total training time at the controls: Location, date and time: Instrument approaches at aerodromes to a decision altitude or height of: Type and number of licence: Type rating instructor Class rating instructor.. instructor of instructor: (s) in capital letters: 3 Flight training: in the aircraft in the FSTD (for ZFTT) Type of aircraft: Registration: Flight time at the controls: Takeoffsoffs, approaches and landings): Training aerodromes or sites (take- Landings Take-off time: Landing time: Location and date: Type rating instructor Class rating instructor of instructor: (s) of instructor in capital letters 4 Skill test Proficiency check Skill test and proficiency check details: Aerodrome or site Take-off time: Total flight time Landing time: Pass Fail Reason(s) why, if failed: Location and date: Examiner s certificate number: of examiner: SI or aircraft registration: Type and number of licence: (s) in capital letters: LIC-FR-276 Rev.No. 1/ EXT-PUB Page 1/1

5 Skill test, proficiency check and assessment of competence applicant's and examiner's declaration APPLICANT'S DECLARATION / IZJAVA KANDIDATA I declare that the information provided on this form is correct and I have been informed of the result of the skill test, proficiency check or assessment of competence. Izjavljujem kako su podaci na ovom obrascu točni, te kako sam upoznat s rezultatom ispita praktične osposobljenosti, provjere stručnosti ili procjene stručnosti. EXAINER SHALL BEFORE TEST / ISPITIVAČ ĆE PRIJE TESTA: (1) ensure that communication with the applicant can be established without language barriers; (2) verify that the applicant complies with all the qualification, training and experience requirements in Part-FCL for the issue, revalidation or renewal of the licence, rating or certificate for which the skill test, proficiency check or assessment of competence is taken; (3) make the applicant aware of the consequences of providing incomplete, inaccurate or false information related to their training and flight experience. (1) osigurati da komunikacija s podnositeljem zahtjeva može biti uspostavljena bez jezičnih prepreka (2) potvrditi da podnositelj zahtjeva ispunjava sve kvalifikacije, zahtjeve osposobljavanja i iskustva Dijela-FCL za stjecanje, produžavanje ili obnavljanje dozvole, ovlaštenja ili certifikata za koji se ispit praktične osposobljenosti, provjera stručnosti ili procjena stručnosti provodi (3) upoznati podnositelja zahtjeva s posljedicama dostavljanja nepotpunih, netočnih ili neistinitih informacija vezano uz njihovo osposobljavanje i letačko iskustvo EXAINER'S DECLARATION: I DECLARE THAT I received information from the applicant regarding his/her experience and instruction, and found that experience and instruction complying with the applicable requirements in Part-FCL. IZJAVLJUJE kako sam primio sve informacije od kandidata vezano za njegovo iskustvo i osposobljavanje, i potvrdio da su iskustvo i osposobljavanje u skladu s primjenjivim zahtjevima Dijela-FCL. EXAINER'S CONFIRATION: I confirm that all the required manoeuvres and exercises have been, and that the applicant's theoretical knowledge has been confirmed by verbal examination (where applicable). Potvrđujem kako su svi zahtijevani manevri i vježbe provedeni, te je potvrđeno kandidatovo teorijsko znanje usmenim ispitivanjem (kada je primjenjivo) ADITIONAL DECLARATION FOR non-ccaa EXAINERS / DODATNA IZJAVAVA ZA non-ccaa ISPITIVAČE I hereby declare that I have reviewed and applied the relevant national procedures and requirements of the applicant s competent authority contained in version (insert document version, i.e ) of the Examiner Differences Document, as published by EASA. Ovim putem izjavljujem kako sam se upoznao i primijenio relevantne nacionalne zahtjeve i procedure tijela nadležnog za izdavanje dozvole podnositelja zahtjeva koje se nalaze u verziji (upiši broj verzije dokumenta, npr ) Examiners Difference Dokumenta, izdanog od strane EASA-e Examiners remarks from skill test/ proficiency check / assessment of competence: Primjedbe i napomene ispitivača s ispita praktične osposobljenosti / provjere stručnosti / procjene stručnosti LIC-FR-313 Rev.No. 2 / INT-PUB Page 1/1